PLA Lash Lift: Step 3 Refill

To finish up the lash lift service, make sure the newly lifted lashes are brought back to life with the PLA Hydrating Serum.

The Hydrating Serum is the final step in the lash lift process. Enhanced with hyaluronic acid, aloe vera, and other nourishing extracts, this solution revitalizes the eyebrow hairs and concludes the lift service.

Please note that this refill pack contains 10 1.5 mL sachets of only Step 3. If you also need Step 1 or Step 2 of the PLA Lash Lift Line, check out our 1-shot or 10-shot packs!

Fast Facts:

• Made in the UK
• Globally compliant
• 100% vegan
• Certified Cruelty free
• 10 x 1.5 mL sachets of Step 3

How To: 

Assess Lashes - 

Lashes must be processed using the correct timing to prevent damage from overprocessing.

• Processing time 5-8 minutes for Lift and Neutralize:
• Very Fine to Fine Lashes - 4-5 minutes
• Medium Lashes - 6-7 minutes
• Thick Lashes - 7-9 minutes

Note: timing maybe affected by room temperature or the amount of glue or balm applied. Cling wrap is not recommended due to potential over processing.

Step 1 Lifting Cream - 

Dispense half the package of Step 1 Lifting Cream into a PLA Tint Dish.

Starting on the outer corner use a microbrush to quickly apply the lift lotion to the base of the natural lash using a dabbing motion ensuring cream has covered the apex of the shield or rod. Once applied, start the timer for the eye. Continue to bring the lotion upwards to mid lash but this must be done quickly. Keep lotion away from the tips of the natural lash.

Repeat with the second eye and start the second timer.

Once the timer goes off, remove all Lifting Cream with a clean applicator, starting from where it was applied. Wipe upwards to remove all cream. Repeat with the second eye.

Step 2 Neutralizing Lotion - 

Dispense half the package of Step 2 Neutralizing Lotion into an unused well in the PLA Tint Dish.

Starting on the outer corner, use a micro brush or applicator to cover the entire lash with a generous amount, start timer for the same time used in Step 1.

Repeat with the second eye and start the second timer.

Once the timer goes off, remove all Neutralizing Lotion with a clean applicator, starting from where it was applied. Wipe upwards to remove all lotion. Repeat with the second eye.

Step 3 Hydrating Serum - 

If no tint is required, apply Hydrating Serum to lashes of each eye. Allow the lashes to dry. Remove shield or rod. Do not remove serum from lashes.

For full instructions, please click here. 

To view the Lash Lift MSDS, click here.